Reasons and preventive measures for the generation of marks and patterns on aluminum die castings
2025-12-15
Characteristics and inspection methods: Appearance inspection shows that there are stripes on the surface of the casting that are consistent with the flow direction of the metal liquid, and there are obvious and visible non directional patterns that are different from the color of the metal substrate, with no development trend.

Reason for occurrence:

1. The metal liquid that first enters the mold cavity forms a very thin and incomplete metal layer, which is then compensated for by the later metal liquid and leaves a trace.

2. The mold temperature is too low.

3. Splashing occurs due to the small cross-sectional area and improper positioning of the sprue.

4. The pressure acting on the molten metal is insufficient.

5. Pattern: Excessive use of paint and injection oil.

Preventive measures:

1. Raise the mold temperature.

2. Adjust the cross-sectional area or position of the sprue.

3. Adjust the speed and pressure of the molten metal in the sprue.

4. Select appropriate coatings, injection oils, and adjust the dosage of coating and injection oils.

Previous:No more content
Next:No more content

Navigation

Send Us A Message

Submit